BBYRB - DENS-COTE PLASTERS (ALL TYPES)

  • MSDS: BBYRB
  • Manufacturer: GEORGIA PACIFIC CORP
  • Product Name: DENS-COTE PLASTERS (ALL TYPES)
  • National Stock Number: 5640-00F007726
Product Identification

Product ID:DENS-COTE PLASTERS (ALL TYPES)
MSDS Date:11/01/1985
FSC:5640
NIIN:00F007726
MSDS Number: BBYRB

Responsible Party
GEORGIA-PACIFIC CORPORATION
2861 MILLER ROAD
DECATUR, GA 30035

Emergency Phone: (404) 987-5190

Info Phone: (800) 424-9300

Preparer: NANCY E. WAGNER

Cage: 00284

Contractor
GEORGIA-PACIFIC CORP
DECATUR, GA 30035

Telephone: (404) 987-5190

Cage: 00284

Ingredients

PLASTER OF PARIS (CALCIUM SULFATE DIHYDRATE)

CAS: 10101-41-4

RTECS: EW4150000

Fraction By Weight: 49-94%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293


SILICA, CRYSTALLINE - QUARTZ

CAS: 14808-60-7

RTECS: VV7330000

Fraction By Weight: 0-49%

OSHA PEL SEE TABLE Z3

ACGIH TLV: 0.1 MG/M3 RDUST;9293


TALC (POWDER), (ASBESTOS FREE)

CAS: 14807-96-6

RTECS: VV7720000

Fraction By Weight: 0-26%

OSHA PEL 15 MG/CUM

ACGIH TLV: 2 MG/CUM (RESP DUST)


MICA - SILICATES (< 1% CRYSTALLINE SILICA)

CAS: 12001-26-2

RTECS: VV8760000

Fraction By Weight: 0-21%

OSHA PEL 20 MPPCF

ACGIH TLV: 3 MG/M3 RDUST; 9293


SILICA-AMORPHOUS DIATOMACEOUS EARTH (UNCALCINED)

CAS: 68855-54-9

RTECS: VV7309000

Fraction By Weight: 0-13.6%

OSHA PEL 80 MG/CUM

ACGIH TLV: 10 MG/CUM (DUST)


CALCIUM OXIDE

CAS: 1305-78-8

RTECS: EW3100000

Fraction By Weight: 0-6.2%

OSHA PEL 5 MG/M3

ACGIH TLV: 2 MG/M3; 9192


STARCH

CAS: 9005-25-8

RTECS: GM5090000

Fraction By Weight: 0-4.4%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3; 9192


PARTICULATES NOT OTHERWISE REGULATED (NUISANCE DUST)

Fraction By Weight: BALANCE

OSHA PEL 15 MG/M3 TOTAL DUST

ACGIH TLV: 10 MG/M3 TDUST; 8990

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: MAY CAUSE DELAYED LUNG
INJURIES, SILICOSIS, PNEUMOCONIOSIS, PULMONARY FIBROSIS, SHORTNESS
OF BREATH & HEART FAILURE, COUGHING, SNEEZING & NASAL IRRITATION.
SKIN: MAY CAUSE BURNS IF LARGE M ASS IS IN CONTACT W/SKIN DURING
HARDENING (HYDRATION); MAY DRY SKIN. EYES: MAY CAUSE IRRITATION.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:INHALATION: MAY CUASE DELAYED LUNG INJURIES,
SILICOSIS, PNEUMOCONIOSIS, PULMONARY FIBROSIS, SHORTNESS OF BREATH
& HEART FAILURE, COUGHING, SNEEZING & NASAL IRRITATION. SKIN: MAY
CAUSE BURNS & DRY. EYE S: MAY CAUSE IRRITATION.

First Aid

First Aid:INGESTION: PRODUCT MAY HARDEN ON CONTACT WITH WATER. MAY
RESULT IN OBSTRUCTION IF INGESTED. SEE PHYSICIAN. INHALATION:
REMOVE TO FRESH AIR. EYE: REMOVE CONTACT LENSES. RINSE EYES WITH
PLENTY OF RUNNIN G WATER FOR 10-15 MINUTES, INCLUDING UNDER
EYELIDS. IF IRRITATION OCCURS, CONTACT PHYSICIAN. SKIN: WASH
PROMPTLY WITH WATER. IF IRRITATION OCCURS, CONTACT PHYSICIAN.

Fire Fighting

Flash Point:NONE
Extinguishing Media:NON-COMBUSTIBLE
Fire Fighting Procedures:NONE
Unusual Fire/Explosion Hazard:NONE

Accidental Release

Spill Release Procedures:SWEEP OR VACCUM SPILLED MATERIAL INTO A WASTE
CONTAINER FOR DISPOSAL. AVOID CREATING EXCESSIVE DUST. WEAR
APPROVED RESPIRATORS IF NECESSARY. DON'T WASH DOWN DRAINS - MAY
PLUG DRAINS.

Handling

Handling and Storage Precautions:BE SURE PROPER VENTILATION &
RESPIRATORY & EYE PROTECTION ARE USED UNDER DUSTING CONDITIONS.
Other Precautions:EXCESSIVE PARTICULATE IN WORKPLACE AIR MUST BE
AVOIDED. WHERE APPLICABLE, USE WET SPONGING IN LIEU OF DRY SANDING
WHENEVER POSSIBLE. DEW POINT CONDITIONS/OTHER CONDITIONS CAUSING
PRESENCE OF MOISTURE WILL HARDEN GYPSUM CEMENT DURING STORAGE

Exposure Controls

Respiratory Protection:WEAR NIOSH-APPROVED RESPIRATOR AS APPROPRIATE
FOR NUISANCE & LUNG DAMAGING DUSTS, ESPECIALLY WHEN SANDING, DRY
GRINDING, CRUSHING & MILLING.
Ventilation:PROVIDE LOCAL EXHAUST VENTILATION TO KEEP Protective Gloves:DESIRABLE
Eye Protection:GOGGLES
Work Hygienic Practices:WHEN WET SPONGING IN LIEU OF DRY SANDING WHEN
POSSIBLE.
Supplemental Safety and Health

Chemical Properties

Spec Gravity:2.5
pH:8.5-10
Solubility in Water:<0.2%
Appearance and Odor:WHITISH, GREY OR BUFF POWDER; LOW ODOR

Stability

Stability Indicator/Materials to Avoid:YES
(CRYSTALLINE SILICA): ENDOTHERMIC - DISSOLVED BY HYDROFLUORIC ACID.
Stability Condition to Avoid:HYDROFLUORIC ACID
Hazardous Decomposition Products:NONE

Disposal

Waste Disposal Methods:MAY BE DISPOSED OF AS INERT SOLID IN SANITARY
LANDFILL OR BY OTHER PROCEDURES IN ACCORDANCE WITH ALL FEDERAL,
STATE & LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.